Viewing code and executing the Route
Procedure
-
Click the Code tab at the
bottom of the design workspace to look at the generated code.
As shown in the code, a message Route is built from "Starter_cTimer_1", set the message body "to cSEDA" by "cSetBody_1", and sent to cSEDA_2, which is mapped to "SEDA_consumer_cSEDA_1". The message is then sent to cVM_2, cDirect_2 sequentially which is mapped to its corresponding consumer with a new message body. On the consumer side, the message body from each consumer is logged by the corresponding monitor. -
Click the Run view to display it and
click the Run button to launch the
execution of your Route. You can also press F6 to execute it.
RESULT: The message that is sent to SEDA_producer, VM_producer, and Direct_producer is consumed by SEDA_consumer, VM_consumer, and Direct_consumer respectively. The message exchange is triggered twice as set in the Route Resource SetRepeatCount.