Activate the extractors for Replicate
After importing the transports, you need to activate them before configuring the Replicate SAP Extractor endpoint.
As the transport installations are not automatically validated by Replicate, it is strongly recommended to validate the installations before running tasks with the SAP Extractor endpoint.
To do this:
-
Open the Replicate for SAP Extractors launch pad through transaction /QTQVC/EXTREP.
-
Create a logical system for the Extractor solution to use as follows:
Information noteThis should be separate from any other Logical System present in the system.
- In the Configuration section, click the Target Logical System button.
-
In the Target Logical system field, enter a technical name for the Logical System and then click Create.
This will create the Logical System and setup its associated RFC connections for use by the Replicate endpoint.
The following confirmation should be shown:
Successfully created logical system.
- Activate the extractors to associate them with the Logical System as follows:
- In the Configuration section, click the Activate Extractors button.
Using the Logical System created earlier, select the extractor (also known as DataSource) you wish to activate from the list of available extractors.
Information note- An extractor may be missing from the list if it has not yet been activated in the ECC system in transaction RSA5.
- Activated extractors will be recorded in the ROOSPRMSC and ROOSPRMSF tables associated with the Logical System.
Click Activate to start the activation process.
You should see a confirmation message at the bottom of your screen.
- Repeat steps b-c for any additional extractors you wish to activate.
To confirm successful activation of the extractors, click Manage Extractors.
The Manage Extractors window opens.
In the Manage Extractors window, you can verify which extractors have been activated for your Logical System and manage their use.
Once you have confirmed that the required extractors have been activated, you can then configure the SAP Extractor endpoint settings in Replicate.