Launching Talend Runtime and its Infrastructure Services

Talend Runtime includes the execution server, Talend Runtime Container and its infrastructure services, including: Service Locator, Service Activity Monitoring and Security Token Service.

To fully benefit from all these functionalities, do the following:

Procedure

Go to subdirectory <TalendRuntimePath>\container\bin of the Talend Runtime installation directory.
Run the trun.bat (Windows) or trun.sh (Linux) file.
When the container starts up, you will see a short introduction (similar to the one below) followed by the Talend Runtime Container console command prompt:
```
Hit '<tab>' for a list of available commands
and '[cmd] --help' for help on a specific command.
Hit '<ctrl-d>' or type 'system:shutdown' to shutdown TRUN.
karaf@trun()>
```
After starting the Talend Runtime Container, wait a few seconds for initialization to complete before going to the next steps. Karaf, on which the Talend Runtime Container is built, starts the noncore bundles in the background. So even if the console is already available, the commands may not be.
At the Console prompt: karaf@trun>, execute the list command.

This will list all the OSGi Bundles installed in the Talend Runtime Container and let you know if they are active, or not yet.

Results

For more information on how to launch the Talend Runtime Container and each of the above services individually or as standalone, see the Talend Data Fabric Installation Guide .

You can find further information about the Talend Runtime Container and how to get started with it in the Talend ESB Container Administration Guide.

For more information on Talend ESB Infrastructure Services, see the Talend ESB Infrastructure Services Configuration Guide.

Did this page help you?

If you find any issues with this page or its content – a typo, a missing step, or a technical error – please let us know!

Leave your feedback here